Bituminous-polymeric mastic for pasting of bituminous roof-tiles, joints encapsulating between bituminous materials. It is distinguished with high stickiness. Does not trickle down at big slopes. Saves its ductility at up to -10°Ñ thanks to consisting of high-quality polymeric materials.
Application
For pasting of bituminous roof-tiles and other materials on bituminous base.
For pasting of bituminous materials to brick, concrete, metallic, wooden, ceramic or other surfaces.
Usage instructions
1. Clean the surface from dust, oil, freezing over, etc. Do not lay on the mastic over moist base. Cut the bottle screw head above the threading, wind on the nozzle and cut the tip at an angle of 45 degrees.
2. Lay on the mastic in zigzag or spot over one of the surfaces, using a gun.
3. Join the surfaces. Avoid fold and bubbles forming. Press the surface till mastic appears from edges.
Temperature range from -5°Ñ to +40°Ñ.
Consumption: kg/meter
When pasting ridge tiles - 0.1 kg/m (laying on width - 10 cm)
When pasting on slop- 0.4 kg/m (laying on width - 20 cm)
When pasting on brick-walls , pipes- 0.75 kg/m ( laying on width - 50 cm)
When pasting padding material joints- 0.1 kg/m (laying on width - 10 cm)
Consumption increasing does not drive to better pasting !
Technical indicators
Indicators
Value
Sturdiness of cohesion with the base, MPa
- with concrete base
- with metallic base
0.5 0.8
Sturdiness of cohesion between layers, MPa
- roll with roll
- Roll with concrete
0.5 0.5
Total part of non-volatile components
75
Displace strand of pasted unit, êÍ/ì, not less than
4.0
Heat-resistance, °Ñ
110
Preservation
Keep in dry, unlit rooms by temperature from -20°Ñ to +35°Ñ
Packing
Cartridge 310ml (380g), in boxes by 24, packed in euro palette by 75 boxes .
Bituminous-polymeric mastic for pasting of bituminous roof-tiles, joints encapsulating between bituminous materials. It is distinguished with high stickiness. Does not trickle down at big slopes. Saves its ductility at up to -10°Ñ thanks to consisting of high-quality polymeric materials.
1. Clean the surface from dust, oil, freezing over, etc. Do not lay on the mastic over moist base. Cut the bottle screw head above the threading, wind on the nozzle and cut the tip at an angle of 45 degrees.